pool depth
英 [puːl depθ]
美 [puːl depθ]
网络 余铁深度; 熔池深度
双语例句
- The water in this pool keeps in its depth the memory of her swimming limbs, and her wet feet had left their marks, day after day, on the footpath leading to the village.
池水深处还保留着她手臂戏水的记忆，通往村中的小径上还印着她每天经过时潮湿的足迹。 - The swimming pool is3 metres at its greatest depth.
游泳池最深处为3米。 - Effect of VaR remelting parameters on pool depth
调整工艺参数对真空自耗重熔锭熔池深度影响的研究 - Add metal from the rod by dipping the end into the pool so that it melts and makes up the vee. The waterlogging depth has significant effects on the growth and morphological structure of Taxodium ascendens.
将焊条一端浸入池内熔化，填满V形坡口。浸水对池杉的生长及其形态结构影响很大。 - I locked the wheels of the wheelchair and walked to the side to show Tom that the pool was the same depth everywhere.
我锁住轮椅的轮子，走到池边，让他看池里每一处都一样深。 - The Jurassic shallow gas pool at Sandawan in Longquan Mountains is a secondary one with shallow depth, low pressure and low yields.
龙泉山三大湾侏罗系浅气藏是一个埋藏浅、压力低、产量小的次生气藏。 - Analytical Model and Relevant Factors of Molten Pool Depth in Case of Laser Cladding with Powder Feeding
送粉式激光熔覆熔池深度的分析模型及其影响因素 - On the basis of above results, the mutual relationships among temperature, molten pool depth, mass transfer distance, parameters of the laser and properties of materials were carefully discussed.
根据计算结果，分析了温度、熔覆深度、界面传质过程与激光参数、材料性质及时间的关系。 - Effect of surface active flux on welding pool depth and arc phenomenon in TIG welding
表面活性剂对TIG焊电弧现象及焊接熔深的影响 - This paper deals with the research and analysis of the situation of the seam pool depth control technique in the arc_welding process at home and abroad. The key technical problems to be solved are expounded and the future development of the pool depth control is deeply probed.
对国内外弧焊过程焊缝熔深控制技术的现状进行了分析和研究，阐述了目前熔深控制中需要解决的关键技术问题，对熔深控制技术的发展趋势作了深入探讨。 - Effect of ESR remelting parameters on pool depth
调整工艺参数对ESR熔池深度影响的研究 - The result shows that the diameter of plasma arc beam becomes smaller, the stiffness and the stability increase and arc starting is easier, the pool depth of the deposition layer increases and the pool width decreases after laser acts on plasma arc.
试验结果表明：激光作用于等离子弧后，等离子弧柱的直径变小，挺度增加，稳定性增强，起弧容易，熔积层的熔深增大，熔宽减小。 - Effect of Modulating Remelting Power on Pool Depth of Electroslag Remelting
调整功率对电渣重熔（ESR）熔池深度的影响 - Biogenic gas pools discovered in China are stored in Quaternary-Cretaceous. Their pool types are simple and the buried depth is less than 2000m.
中国已发现的生物气藏分布于第四系&白垩系，埋深小于2000m，生物气藏类型比较简单。 - The temporal and spatial distribution and evolution of the SCS warm pool is investigated using the water temperatures at a depth of 20 m in the sea. The formation of the warm pool is discussed by combining water temperatures with geostrophic currents and simulated oceanic circulation.
本文主要采用南海20m层的水温分布资料，讨论了南海暖池的时空演变特征，并结合地转流和海洋环流数值模拟的结果探讨了暖池的形成机制。 - The results show that whether the arc of A-TIG welding shrinks is related with active flux used. The surface active flux still has the effect on weld pool depth even when arc does not shrink.
结果表明，A－TIG焊电弧是否产生收缩与所使用的活性剂有关，即使在电弧未产生收缩情况下，表面活性剂仍然对焊接熔深的增加有较大的作用。 - Based on the form, energy dissipation characteristic of suspended grid plunge pool, the change of water depth of plunge pool and swell in downstream before and after putting suspended grid are further analyzed in this paper.
通过试验研究，进一步分析悬栅消力池的消能特性，加栅前后消力池内水深及消力池下游明流洞内涌浪的变化。 - And the effect of SPreading fusion of active flux on weld pool depth and arc phenomenon in A-TIG welding is also studied with properly experimental method.
采取适当的试验方法研究A－TIG焊活性剂对电弧现象及活性剂涂敷量对焊接熔深增加的作用。 - The results show that the unsteady state process of fluid flow and heat transfer in laser molten pool is a preheating process as the highest surface temperature, depth and radius of the molten pool increase with the scanning time.
结果表明，激光熔池对流传热非稳态过程是一个预热过程，随着时间的推移，熔池最高温度不断升高，熔深和熔池半径不断增大。 - Therefore, before the experiment in the laser cladding, cladding need mathematical model predicts the pool depth, the development process parameters.
因此，在激光熔覆实验之前，需要数学模型预测熔覆层的熔池深度，拟定工艺参数。 - Numerical simulation study on heat and mass transfer process and the use of CFD technology to the molten pool smelting blowing stirring, to investigate the effect of injection speed, depth of the bath flow and bath splash damage to the furnace wall is very necessary.
因此利用CFD技术对熔池熔炼喷吹搅拌的传热传质过程进行数值模拟研究，探讨喷吹速度、深度对熔池内流型的影响以及熔池喷溅对炉壁的破坏作用是十分必要的。 - The content of simulate including in flotation pool or without grating angle, whether the flap angle, different depth ratio of flotation effect analysis.
主要是对气浮池中有无格板及其角度、有无挡水板及其角度、不同长深比下对气浮效果的影响进行了分析。 - In the data acquisition, object pool based mobile agent object management is studied in depth.
在数据获取方面，重点研究了基于对象池技术的移动Agent对象管理。 - There were three types of the oil and gas accumulation model: Primary pool near to depression, Adjustment pool controlled by source rock and fault, and Secondary pool with shallow depth.
综合分析文留油气藏的成藏模式主要有三种类型，及近洼自生型、油源断层控制的调整型、与浅层次生型。 - Increase of the voltage makes the pool surface temperature increased only, without obvious increase of penetration depth.
弧压升高，熔池表面温度增加，但是熔深增加不明显。